As you may have guessed, this is not about the obvious, described in the instructions. Disassembly is of interest to us solely for the purpose of repair or cleaning, if the appliance suddenly starts to fiddle. Let's find out, how to disassemble at home centrifugal juicer "Cranberry".
stages of disassembly
No matter how reliable the thing, over time, it may fail. This may be due to overload during operation, pollution, leakage of various liquids on electrical parts, which can lead to short circuits and breakdowns.
For repairs, we need to get to the compartment with the electric motor, which is located in the lower part of the juicer "Cranberry", so you need to start disassembling it from above (more about the internal design - the device and principle of operation of a modern juicer). But even after removing all removable parts from it, involved in grinding vegetables, you will not see any more latches or fasteners, allowing to disassemble an engine compartment.
However, this is only visibility: in fact, there are no special difficulties here. All cover mounting screws are hidden under the plastic disc, to which a metal grater was screwed for grinding products. It just "sits" very tightly on the motor shaft and to remove it, considerable effort is required.
To do this, put the juicer on the floor and holding it with your feet or with assistance, carefully pull the plastic disc off the shaft with your hands, trying not to allow large inflections. It may not work out the first time, but attempts should continue. The main thing is not to overdo it and not to break anything.
You will find four screws under the disc, unscrewing which, you divide the body of the juicer into two parts and get access to all its entrails and, perhaps, guess the causes of the fault.
Knowledge of the internal device can be useful to you when creating a homemade juicer.
features of repair
Self-repair of all types of juicers, including "Cranberry", comes down to replacing failed parts, such as: wires, switch, bearings or electric plug. But most often you just need to clean the engine compartment (and the motor itself) from got into it during the operation of garbage: saw, juice, cakes, etc.. Perhaps, lubrication of moving parts will still be required.
But if the winding of the electric motor burns out and it does not work in the presence of voltage at the terminals (this can be determined with the help of an electric tester), then without the help of a specialist can not do here.
Rewinding the winding requires not only knowledge of electromechanics, but also the availability of special tools and consumables.
Read also: how to repair a juicer with your own hands.
conclusion
Juicer "Cranberry" made in Belarus is just as reliable, as old as. It does not have any complex control chips, which could burn out from a second voltage drop in the network. So it is quite possible to fix it on your own. For her, even the combustion of an electric motor is not critical, since it is repairable, unlike modern models of juicers.