Many music lovers, who do not part with her anywhere, and constantly use headphones, face the most common problem: the accessory is tangled. The question immediately arises, how to make, so that the headphones are not confused or broken. Why headphones are confused, it is not necessary to explain, after all, carrying in your pocket and among things in a bag easily contributes to this. With prolonged and careless untangling quickly, you can even break quite fragile wires. Therefore knowledge, how to properly store headphones, so that they are not confused, will be useful to many.
How to twist wires
There is a fairly simple way, which will prompt, how to make, so that the headphones do not break or get confused, and were easily and quickly available for operation. The method is very simple, everyone can handle it.
- The fingers are folded in the form of a goat (little finger and index finger unfold, while others remain concise).
- The beginning of the headphones is clamped between the little finger and the index finger, and the wire begins to wind on the fingers of the figure eight.
- Then the remaining end is wound on the center of the twist, and everything is ready. You can safely put the gadget in your pocket, the wires will remain neatly wound, and it is also easy to unravel.
This is the easiest way, how to protect wires - during such storage they are not confused. But today there are a lot of other options, in which the accessory also does not break.
Cardboard to help
If you need to place devices on the table, and a tangle of tangled wires is annoying, you should think, how to store headphones as convenient as possible, using the tools at hand. To implement the easiest option, you need to take ordinary cardboard from any box, scissors. This method is very easy to implement with your own hands. To make such a holder, you only need to cut a figure out of cardboard in the form of a bone. And then everything is simple: the wires are wound in the center, neatly fastened.
Old lipstick can come in handy
Arrange a case for storing headphones, so that the wires do not get tangled, you can use a lipstick lid - in any house you will find a used lipstick.
- The wires of the device are wrapped around three fingers in a tight ring so, so that the plug and inserts are at the bottom.
- Then the upper edge of the twist should be pushed into the lid. Sometimes wires are difficult to insert the first time, but it's for the better: the headset will hold firmly inside the "case". It is worth twisting a little - the wires will fall into place.
Plastic card
How to do it, so that the headphones never get confused? Make a special case for them. Almost everyone has an unnecessary or non-working plastic card, example, discount or expired. It can be used to advantage. It can make a great case for the headset. In addition to the card, you will need a regular hair elastic.
- The eraser is stretched along the card in length in this way, so that it is located in the center.
- Then they wrap around your fingers, so that the winding turned out round.
- The headset is carefully inserted between the card and the rubber band. To make it easier to do, the map should be folded in the form of a pocket at both ends.
- The field of, as an accessory will be placed neatly in the right place, you should stop squeezing the edges - now they will be held by an eraser.
Accessory, wrapped in a similar way, convenient to store, even carry in your jeans pocket. The wiring remains neatly folded and does not break.
Knowing such simple ways, now you can rest easy - your favorite headset will stay neatly folded and easily untangled. The devices will be up and running at any time.