Cannon drills and drills for deep drilling: see, GUEST

The gun drill is a tool, by means of which drilling of through and deaf openings is carried out, differing in considerable depth. Holes of this type are made in shafts for various purposes, in spindles, as well as in other details, characterized by considerable length. Not only gun drills are used for this purpose, but also, in particular, single-edged and double-edged drills with internal chip removal. Drilling with the help of the latter is characterized by low productivity, but deep holes are characterized by high purity, accuracy of geometric parameters and straightforwardness.

The process of deep drilling at the turning and milling center

Features of drilling deep holes

Drilling is called deep in that case, if the depth of the hole exceeds five of its diameters. This technological operation is highly complex and time consuming, and the main condition for its quality performance is effective cooling of the tool, which, usually, carried out under pressure.

To perform deep drilling efficiently and accurately, it is very important to ensure the correct direction of the tool at the very beginning of processing. To do this, use a special conductor sleeve or perform this procedure on pre-made holes of smaller diameter.

Due to technical difficulties, deep drilling should be performed on special equipment

Drill, used for deep drilling, cannot be rotated at full speed outside the workpiece itself: this can shift the cutting part from the required trajectory. in addition, when drilling deep holes with a long drill creates unfavorable conditions for the removal of chips from the processing area, which can also cause the tool to deviate from the specified direction.

Types of drills for deep drilling

As a drill for deep drilling can be used:

• spiral with a cylindrical shank, parameters of which are regulated by GOST 886-77 (on the design spiral drills with a cylindrical shaft concern tools of a long series, with which to create holes with depth, exceeding the value, equal 15 diameters);
• rifles, the cutting part of which is made entirely of hard alloy;
• rifles, on the cutting part of which carbide plates are fixed by soldering;
• rifles, equipped not only basic, but also intermediate carbide plates;
• ejector, which are used to perform deep drilling on machines with a horizontal arrangement of the cutting tool;
• cannon, on the surface of which there is a V-shaped groove, designed to remove chips (machining with drills of this type is an outdated method of obtaining deep holes).

Drills for deep drilling

It is possible to get acquainted with requirements of GOST to drills of a long series, by downloading the document in pdf format at the link below.
GUEST 886-77 Spiral drills with a cylindrical shank. Long series. Basic dimensions
Download

Twist drills with a cylindrical shank, manufactured in accordance with the requirements, which provides GOST 886-77, differ in the extended working part. In accordance with the provisions of the above standard from the 77th year, such an elongated tool can be made entirely of high-speed steel or equipped with cutting inserts, made of hard alloy.

GUEST 886 from the 77th year also determines, that cooling of drills of this type can be provided at the expense not only external, but also the internal supply of coolant. Twist drills, as indicated by GOST 886-77, can be made not only with a cylindrical shank, but also with conical shanks. The process of deep drilling, carried out using such drills, can be performed as with their periodic extraction from the performed hole, what is needed to remove from it formed chips, and without performing such a procedure. If you compare twist drills with armed and cannon, then when using the first drilling performance increases almost in 8 times.